Multi-Tech MultiFRAD FR2201, Быстрый старт

Страница: 10 / 28

MultiFRAD II Quick Start Guide
Table 1. Cabling Procedure
Step Procedure
1 Connect one end of a DB25 back-to-back cable to each of
the data channel connectors on the back of your
MultiFRAD (labeled CHANNEL 1-2). See Figure 3.
Connect the other end of each cable to a channel device.
NOTE: Both channels support the RS232/V.35 protocols,
and either asynchronous or HDLC synchronous RS232
data equipment such as multiplexers.
2 Connect one end of an DB25 (female) cable to the Trunk
connector (Figure 3). Connect the other cable end to your
T1 CSU/DSU or compatible link device.
3 To make the network connection, connect an RJ45 (UTP)
cable to the 10 BASE-T Ethernet connector or the male
connector for a 10Base5 cable to the AUI Ethernet
connector (shown in Figure 3). Connect the other end of
the cable to your LAN.
4 Connect the MultiFRAD to your PC with a standard RS232
cable. Plug the male end of the cable into the Command
Port (Figure 3) and the other end into the PC’s serial port.
5 Connect one end of the power supply to a live AC outlet,
then connect the other end to the MultiFRAD as shown in
Figure 3. The Power connector is a 7-pin circular DIN
connector.
6 Apply power to the MultiFRAD by setting the Power switch
(Figure 3) to the “1” (on) position.
At this time your MultiFRAD is completely cabled. Proceed to the
next section to install your software.
10