The Stick II
The Stick II
1 4
3 5
Q:
What happens if Bob is on the phone?
A:
You will hear a busy signal.
Q:
What if both Line 1 and Line 2 are in use, can I still make an
Port-to-Port call?
A:
No. You need an outbound line to initiate the Port-to-Port
communication.
Port-to-Port Priority
This feature determines whether a communication or data transfer from Port-to-Port on
The Stick II’s “internal line” takes precedence over an incoming call. Your choices are either
"ON WITHOUT BEEPS","ON WITH BEEPS", or "OFF". With this feature "ON WITHOUT
BEEPS", your Port-to-Port communications/data transfer will go uninterrupted when a call is
received. With this feature "ON WITH BEEPS", The StickII will produce beeps similar to Call
Waiting beeps from the phone company when an incoming call is detected. When a beep is
heard, you have the option of continuing the Port-to-Port communication, or hanging up and
accepting the incoming call. With this feature "OFF", your Port-to-Port communication will be
immediately dropped and the incoming call will be processed. When Port-to-Port communi-
cation is taking place, priority is set to "ON" with or without "BEEPS", and an inbound call is
ringing, any device not in use and defaulted to the ringing line will obtain the line simply by
going off hook. The factory default is set for "ON WITHOUT BEEPS". Remember, Port-to-
Port priority applies only to devices connected to the StickII while using Port-to-Port commu-
nication.
Q:
What does the caller hear if I am using one of the ports that the call
should go to?
A:
The caller would hear the phone ringing. If you choose not to disconnect
from your Port-to-Port, then the caller would have to hang up.
Q:
Say I have two fax machines connected to The Stick II. I am using one
as a scanner and dialing my computer modem over the internal line. A
fax call comes in on Line 1. What will happen to the call?
A:
During a Port-to-Port call, The Stick II does no call processing other than
detecting rings and beeping, if BEEPS are turned ON. The ports in the
Port-to-Port call will be connected to their default line.
