Multenet PocketPAD Power over Ethernet, Руководство пользователя

Страница: 44 / 80

4 4 C O N F I G U R AT I O N 4 4
M U LT E N E T P O C K E T P A D
TCP Application Parameters overview:
TCP Application - This is the label you entered at the time of adding the Application.
Serial Port - Indicates the Serial Port to which these changes will impact. This
defaults to com1 on the PocketPAD 1. You can choose the Serial
Port on the PocketPAD 2 and PocketPAD 4 (as seen in the figure
below).
Connection Type - Default is Passive.
Passive - Application accepts incoming TCP socket connections
from remote hosts.
Set ‘ Remote Host ’ & ‘ Remote Port ’ to accept
connections from that specific Host:Port. This can be
used to block unwanted access to the Serial Port data.
Active - Application connects to a remote Host during the
bootup cycle. The ‘ Remote Host ’ & ‘ Remote Port ’
needs to be set.
Local TCP Port - The local TCP Port to which socket connections are made from
remote Hosts. Default is 5000. Valid Port numbers are between 502
& 65534.
Remote Host / IP Address - Must be set if ‘ Connection Type ’ is Active . TCP Socket
connections from this IP Address are initiated or accepted.
Default is ‘null’ (accept any Remote IP Address connection).
Remote TCP Port - Must be set if ‘ Connection Type ’ is Active . TCP Socket
connections to this Remote Port are initiated or accepted.