Copyright Müller-Elektronik GmbH u. Co. UNI-Control S Installation and User´s Guide (01/95) Seite - 9 -
2
Fitting instructions
2.1
Console and computer
The
computer console
(14) should be mounted on the cabin within view and reach of the driver on the
right hand side and in such a way that it conducts electricity. The distance to the transmitter or antenna
should be at least 1 m.
The
bracket
(13) is attached to the console´s tube.
The
profil slide
(10) is mounted on to the bracket. The UNI-Control S
computer
(1) is pushed on to the
profile from above and secured with the wing-bolt.
The ideal angle for viewing the display from below lies between 45º and 90º. It can be adjusted by
swiveling the console.
Attention!
The computer cabinet must be wired to the tractor chassis via the console. When
assembling remove the color from the assembly points.
2.2
Tractor distributor for tractors without signal sockets
The
battery connection cable
- computer (17) and the sensors (18 - 21) are connected to the
tractor
signal distributor
(16
)
. The sensor X (20) (cardan shaft/wheel) is supplied as standard.
The
sensor Y
(18) (working position), the
power take-off shaft rotation sensor
(19) and the
radar
device
(21) can easily be retro-fitted.
The
tractor signal distributor
(16) is screwed on to the computer console or to another position on the
tractor with the mounting plate.
The tractor signal distributor is not required when the UNI-Control S is only being operated on an attached
field sprayer. The voltage supply is taken from the switch box. The distance impulse is taken from the
wheel of the sprayer.
2.2.1 Battery connection cable - computer
The voltage supply must be taken directly from the battery or from the 12-volt starter. Care should be
taken when laying the
cable
(17) and it should be shortened if necessary. The
crimpon ring terminal
for
the ground line and the end sleeve for strands for the + line (brown) should be fitted with suitable pliers.
The end sleeve for strands for the + line are in the connection clamp of the fuse holder. The battery
connection cable has a 5- ampere fuse.
brown = + 12 volts
blue
= ground
Attention!
The battery´s minus pole must be connected to the chassis of the tractor
www.ROLTRONIK.pl
