MTS Exceed™ 22 Series Product Information
Troubleshooting
57
Troubleshooting
Troubleshooting of Common Faults
Fault Description
Solution
The touch screen is not on or
displays incorrectly when the
equipment is powered on.
•
Check whether power cord is plugged in.
•
Check whether the voltage is within the predetermined range.
•
Check whether touch screen control box is solidly wired, without
loosening.
After the system is powered on, it
has no responses when buttons
are pressed.
•
The inverter reports error. Power off the equipment and then power it
on again after 10s.
•
Check whether the equipment is cleared to zero.
•
Check whether shields are closed.
•
Check whether the gas source is normal.
Impact toughness in printed
results is inconsistent with
manually calculated result.
•
Check whether thickness and width of specimen are mixed when
entered into the software.
Test result is quite different from
known specimen toughness.
•
Pendulum specifications are incorrectly set. Enter specifications
mapping the pendulum on the parameter selection interface of the
touch screen.
•
Specimen specifications are incorrectly set. Enter specifications
mapping the specimen on the parameter selection interface of the
touch screen.
The printer does not work.
•
Check whether the printer is well connected to the electric control box.
•
Check whether the printer functions normally. For details, see the
product manual of the printer or contact the manufacturer.
The control panel is not working
properly, or does not work.
•
Communications cable are not well connected. Check the two ports at
the two ends of the communications cable.
•
Check whether the LUC is damaged. If yes, contact MTS customer
service or return it to MTS factory for repair. You are not allowed to
open it on your own.
Clutch does not work.
•
Check whether the brush is damaged. If yes, replace the brush.
•
Check whether the clutch tooth surface is damaged. If yes, replace the
clutch.
Hook has no response.
•
Check whether air pressure is normal and gas pipes are correctly
connected.
•
Check whether solenoid valves work properly.
Brake failure
•
Check whether air pressure is normal and gas pipes are correctly
connected.
•
Check whether solenoid valves work properly.
Friction loss is greater than
deviation range.
•
This may also be caused by dirt in or damages of the ball bearing. In
this case, remove the bearing and then clean or replace it. The bearing
should have no grease before installation. Then, re-install the bearing.
Содержание Exceed 22 Series
