MTP 1750 Series, Руководство пользователя

Страница: 39 / 50

Series 1750 Bedding Dispensers
61301604063 6–5
STARTUP
To ensure proper machine startup, follow these steps:
1. Ensure that all utilities are properly connected to the
machine and tightened.
2. Verify all incoming power supplied by the customer is as
called out on the equipment specifications.
3. Turn ON the mains disconnect.
4. Turn ON the POWER switch on the control panel.
The POWER indicator lights.
If not, check the fuse on the control panel and the power
supply to the control box.
5. Check the motors to ensure they are in proper rotation.
6. Ensure that the dust collector is attached and properly
wired to the unit.
CHECK-OUT
Fill the hopper
1. Open the hopper lid. Keep the safety gate in place.
2. Partially fill the hopper with bedding.
NEVER OVERFILL THE HOPPER CAPACITY.
Otherwise the dispenser drive may jam. If this occurs, see “TO CLEAR THE
DISPENSER DRIVE” on page 5–2.
Run the unit
1. On the control panel, turn ON the CONVEYOR DRIVE.
As soon as the DISPENSER DRIVE is ON, bedding will travel from the hop-
per to be dropped onto the conveyor. Do not turn ON the DISPENSER
DRIVE until you are ready for this to occur.
2. On the control panel, turn ON the DISPENSER DRIVE.
• Turn this switch ON to fill the cages with bedding.
• Keep this switch OFF to let the cages pass through
without filling.
3. On the control panel, turn ON the DUST COLLECTOR
(option).
4. Press START.
5. Adjust the speed of the DISPENSER DRIVE.
CAUTION