Installation and Operational Manual
•
Boutique Collection
•
SculptureStone® Tubs
1 / mtibaths.com
Do not permit children to use this unit unless they are closely supervised by an adult at all times. Supervision is also required when bath
is used by an elderly or handicapped individual.
Never leave a full or filling bath unattended.
Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. Never
drop or insert any object into any opening.
The water in a bath should never exceed 40˚ C (104˚ F). Water temperatures between 38˚ C (100˚ F) and 40˚ C (104˚ F) are considered safe
for a healthy adult. Use time should be limited to approximately 10 minutes, followed by a shower to cool down. Longer exposures may
result in hyperthermia, which can be fatal. The symptoms of this condition are nausea, dizziness and fainting. Lower water temperatures
are recommended for extended use (exceeding 10 - 15 minutes) and for young children.
Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or
possibly pregnant women should limit water temperatures to 38˚ C (100˚ F).
The use of drugs or alcoholic beverages before or during bathing may lead to unconsciousness with the possibility of drowning. Never
use the bath while under the influence of alcohol, anticoagulants, stimulants, antihistamines, vasoconstrictors, vasodilators, hypnotics,
narcotics or tranquilizers.
Persons using medication should consult a physician before using a bath since medication may induce drowsiness while other
medications may affect heart rate, blood pressure and circulation.
DANGER:
To reduce the risk of injury, enter and exit the bath slowly.
Never operate electrically connected devices in or within 5' of the bath. Never drop or insert any object into any opening within the bath.
Risk of electric shock. Connect only to circuits protected by a Ground Fault Circuit Interrupter (GFCI). Such a device should be installed by
a licensed electrician and should be tested on a regular basis (at least monthly). To test the GFCI push the TEST button. The GFCl should
interrupt the power. Push the RESET button and the power should be restored. If the GFCI fails to operate in this manner there is the
possibility of an electric shock. DO NOT USE. Disconnect the unit and have the problem corrected by a qualified service technician. To
avoid the possibility of personal injury and discoloration of the acrylic surface, the inlet water temperature should not exceed 60˚ C (140˚ F).
Disconnect power before servicing.
A pressure wire connector is provided on the exterior of the pump or control within this unit to permit connection of a bonding conductor
between this unit and all other exposed metal in the vicinity, as needed to comply with local requirements.
INSTALLER/OWNER BEARS ALL RESPONSIBILITY TO COMPLY WITH ALL
STATE AND LOCAL CODES WHEN INSTALLING THIS PRODUCT.
IMPORTANT:
When required by local codes, install a RPZ (Reduced Pressure Zone) backflow prevention device to each faucet supply
line.
Important Safety Instructions
This manual contains information and instructions for proper operation and maintenance of your MTI bathtub. Failure to follow these
instructions could result in personal injury, electrical shock or fire.
WARNING: WHEN USING ELECTRICAL PRODUCTS, BASIC PRECUATIONS SHOULD BE
FOLLOWED INCLUDING THE FOLLOWING:
SAVE THESE INSTRUCTIONS
