Installation and Operational Manual
•
Boutique Collection
•
SculptureStone® Tubs
10 / mtibaths.com
1. ON/OFF
2. BLOWER SPEED INCREASE
3. BLOWER SPEED DECREASE
4. SPA MODES
1st Press:
The blower starts. LED light on.
Press & hold to increase the blower speed. Release
pressure at the desired speed.
The system is equipped with two sensors on the floor of the bath near the drain. Every time water is introduced
to the bath and drained, either by showering, bathing or cleaning, the sensors will activate the drying cycle.
The cycle will start approximately 7 minutes after the bath is drained and run for 1-2 minutes. The drying cycle
will activate even when the air system has not been turned on. The blower LED blinks (on keypad only) during
the drying cycle countdown. This countdown cannot be cancelled. Any attempt to cancel this cycle only resets
the countdown timer.
Press & hold to decrease the blower speed. Release
pressure at the desired speed.
2nd Press:
The blower stops. LED light off.
1st Press (Wave):
Speed will vary gradually from
maximum to minimum. LED light on.
2nd Press (Pulse):
Speed will go directly to minimum
and then straight back to maximum. LED light will flash.
3rd Press:
Returns to maximum speed. LED light off.
Press button #3 to decrease blower speed.
Note:
The blower initially starts at 30% speed.
Operation Instructions – Airbath Keypad and Remote
Airbath Keypad
Airbath Remote
Control
FUNCTIONS:
Note:
Blower automatically stops after 20 minutes.
STANDARD DRYING CYCLE WITH WATER DETECTORS:
Note:
Numbered instructions depict buttons in photo as seen from left to right on keypad or top to bottom on
remote control.
Please visit
mtibaths.com
OPERATIONAL VIDEOS:
1
2
3
4
1
2
3
4
