Premier
Diesel Engine with PS-2 and Proto-Scale 3-2
9
3GS-21B GenSet
Proto-Sound® 2.0 Operating Instructions
This manual contains the operating instructions for Proto-Sound® 2.0 in
conventional mode only. Instructions for accessing DCS command mode features
accompany the DCS Remote Control System equipment.
Activating Proto-Sound® 2.0 Conventional Mode Features:
Proto-Sound® 2.0 features are activated by sequences of Bell and Horn/Whistle button
pushes described below. Please read the full descriptions of each feature before using it. To
use these buttons to activate features rather than to blow the horn/ whistle or ring the bell,
you should tap the buttons very quickly with a ½-second pause between button presses.
You may need to practice your timing to make this work smoothly.
Freight Yard Sounds (FYS) or
Passenger Station Announcements (PSA):
Your engine is equipped with a sound package of either freight yard or passenger station
sounds that you can play.
Each sequence described below will play as long as it is left
on, randomly generating sounds, but be sure to allow approximately 30 seconds
between the button pushes described below to allow the FYS/PSA sufficient time to
run through each sequence.
!
To cue the sound system to play the FYS/PSA, quickly but firmly tap the Bell button once
followed by 2 quick taps of the
Horn/Whistle button while the engine is moving. Tap the
buttons quickly but allow approximately ½ second between each press.
!
Press the Direction button once to stop the engine. This will trigger the first sequence of
FYS/PSA. The reverse unit is temporarily disabled so that the train will not move as you
use the Direction button to trigger the sounds, and Proto-Sound 2.0 has disabled operator
control over the
Horn/Whistle and Bell buttons until the full FYS/PSA sequence is
complete.
!
After waiting about 30 seconds for that sequence to run, press the Direction button again
to trigger the second sequence of FYS/PSA.
!
After about 30 seconds, press the Direction button again to trigger the third FYS/PSA
sequence.
!
Again, after allowing about 30 seconds for that sequence to run, press the Direction button
one more time to trigger the fourth and final FYS/PSA sequence.
Feature to Be Activated
Button Code:
Freight Yard or Passenger Station Sounds
Fire the Rear Coupler
Fire the Front Coupler
Speed Control On/Off
Lock into a Direction
Reset to Factory Defaults
1 Bell, 2 Horn/Whistles
1 Bell, 3 Horn/Whistles
1 Bell, 4 Horn/Whistles
1 Horn/Whistle, 2 Bells (from Neutral only)
1 Horn/Whistle, 3 Bells
1 Horn/Whistle, 5 Bells (from Neutral only)
Timing Chart
Total Time Lapse: 1
Seconds
½
Press
Whistle
Short &
Firm
½ Sec.
Pause
½ Sec.
Pause
Press
Bell
Short &
Firm
Press
Bell
Short &
Firm
