TAEevo M05-M10
16
The data inside this manual are not binding and they can be modified by the manufacturer without notice.
All rights reserved.
7 . 9
D i g i t a l i n p u t a l a r m s
ALd
Temperature
alarm delay
Time interval between detection of a temperature alarm and
relative signalling
0
255
min
0
dAO
Temperature
alarm inhibit at
start-up
At start-up of the unit the temperature alarm is inhibited for the
time set in this parameter
0
23,5 h
10
min
0
tbA
Alarm relay
deactivation
n= relay active for the entire duration of the alarm
y= the relay is deactivated by pressing with an alarm in
progress
n
AoP
Polarity according
to relay
(oA3=ALr)
Selects alarm relay open or closed during an alarm.
cl
=
terminals 1-2 closed during an alarm;
op
= terminals 1-2 open
during an alarm
oP
Parameter
Description
Min.
Max.
U.M.
Factory
settings
i1P
Digital input
polarity
Serves to set alarm signalling on the basis of:
•
oP= input is activated by contact opening
•
CL= digital input is activated by contact
closing
oP
i1F
Digital input
configuration
Serves to set alarm signalling on the basis of:
•
EAL= external alarm (EA on display)
•
bAL= critical alarm
•
PAL= pressure switch alarm
•
dor= door microswitch
•
dEF= defrost activation
•
AUS= not enabled
•
Htr= reverse action (hot-cold)
•
FAN= not enabled
•
ES= not enabled
•
OFb= not enabled
bAL
did
Digital input
alarm delay
Serves to set the time lag before activation of the digital input
alarm
•
i1F=EAL or bAL delay between detection and
signalling of an external alarm
•
i1F=dor delay on door open alarm signal
•
i1F=PAL time for pressure switch operation: if
nPS activations in time did are reached
restarting is manual only by powering off the
unit and then powering it on again
0
255
min.
0
nPS
Number of
pressure switch
activations
At each activation of the digital input the control is blocked; if
nPS activations are reached in time did restarting is manual
only by powering off the unit and then powering it on again.
1
15
15
odc
Door open control
Determines compressor and fan status with door open
•
no= fans and compressor operate normally
•
Fan= fans OFF
•
CPr= compressor OFF
•
F-C= compressor and fans OFF
F-C
Parameter
Description
Min.
Max.
U.M.
Factory
settings
Table 5
P
ARAMETERS
RELATIVE
TO
ALARMS
MANAGEMENT
