MST Impact NS5001, Руководство пользователя

Страница: 66 / 118

5.5 Settings Tab
5.5.1 Managing Automatic TFTP Configuration
The Config Management screen is used to configure how the device retrieves its configuration from a
TFTP server on the network. For more information on TFTP, see Centralised Configuration Management
on page 85.
Note: These settings only affect TFTP configuration from a ICA v1.3.1 or earlier, and 3rd party
TFTP servers. If using AP Config Templates from ICA 1.4.0 or later, leave Self check disabled
(See Device Management Overview on page 86).
Self Check Settings
To enable automatic configuration from a TFTP server, tick the
Self check enabled
checkbox, enter the
desired
Self check interval
and
TFTP Server Address
, then click the
Save Settings
button.
Change Numbers
The two change numbers shown here are timestamps (formatted as YYYYMMDDhhmmss) showing the
last time the device's settings were updated via TFTP. The
Site Change Number refers to general site
settings applied to all devices, whereas the Device Change Number refers to specific settings applied to
this device.
5.5.2 Configuring SNMP Settings
The SNMP screen contains Simple Network Management Protocol settings. SNMP is a protocol used by
the ICA and 3rd party SNMP browsers to monitor the status of compatible devices on the network. At
present, the ICA only uses this protocol to monitor for Port Up/Port Down errors on the NS50, and is not
affected by the settings below.
Revision C 66 NS50 User Guide
Configuration Using the Web Interface