MRMC MRMC-1479-00, Быстрый старт, Страница: 26 / 37

Titan Quick Start Guide
21
Mounting the rig on a track
Mounting the rig on the track bearings
1. Roll the rig to a position just off the end of the track, ensuring that
the track pinion on the rig is on the correct side of the track.
2. Mount the ramp-ups on to the side of the track. Roll the rig over to
the ramp- ups to raise the rig high enough over the track so that the
track motor gear on the underside of the rig completely clears the
rack (the middle rail on the track). Push the rig to the position over
the ramp-ups so that the track motor gear on the Milo underside is
on the toothed side of the rack.
Do not engage the teeth yet; just
make sure Milo is the correct way around for the track.
3. Push the rig to the levelled part of the ramp-ups and whilst in the
position push the four track bearings under the four corners of the
Milo base making sure that all four bearings are aligned with the
corners of the Milo base, and the track motor gear on the underside
of Milo clears the rack. (The track motor gear is on bearing rails so
you can slide it out of the way to clear the rack.)Drop the four track
bearing bolts in their slots in the Milo without tightening them yet
ensuring they line up with the track bearings.
4. Push Milo further over the ramp-ups on to the bearings on the track
so it drops fully. Tighten the four track bearing mounting bolts at the
corners.
Hint
Always mount and remove the track bearings with care. Try to
keep them squared up and in-line with the bearing rail to avoid
damaging them or loosing a bearing.