MRC DRS2000HS, Руководство пользователя и техническое руководство

Страница: 46 / 68

Installation 4-2 DRS2000HS/6000HS User and Technical Manual
• Check that the equipment is clean and dry.
• Check that no cables or connectors are broken, damaged,
or loose.
• Check that no switches or displays are broken, damaged,
or loose.
4.4 Reporting Any Damage
Should you discover any damage after unpacking the system,
report the damage by following these steps:
• Immediately file a claim with the shipping carrier.
• Forward a copy of the damage report to MRC Customer
Service.
• Contact MRC Customer Service to determine the
disposition of the equipment.
4.5 Installing the DRS2000HS/
DRS6000HS
Each installation or deployment will have its own specific tasks
according to the application and installed hardware. The
following sections describe mounting and cabling the
DRS2000HS/DRS6000HS system.
The DRS2000HS/DRS6000HS Receiver is typically mounted in
a standard 19-inch (48.3 cm) rack. The cabling is permanently
installed and power comes from the facility or site power source.
4.5.1 Site Preparation
The following requirements are designed to make initial
installation easier and to allow room for future access and
servicing.
Equipment Rack The receiver mounts to the mounting rails of
a standard EIA 19-inch (48.3 cm) equipment rack. Each unit
occupies 2 rack units (2RU) of height.
CAUTION Do not overload the rack or load it unevenly.
Secure the rack to a solid surface.
• Make certain that the rack and mounting rails are strong
and rigid enough to support all the equipment in the rack.
• The rack should be securely attached to a solid surface
such as a floor or wall to prevent movement or tipping
over.
• Position the rack to allow easy access to the front and
rear of the equipment.
• Be sure to allow room behind the equipment rack for the
many cables required. The cables should not be pressed
against the rear of the equipment when closing doors.
This will stress the cables and may shorten their life.
4.5.2 Mounting the DRS2000HS/DRS6000HS
Mounting the DRS2000HS/DRS6000HS receiver into an
equipment rack is easier if one person holds the unit while
another person installs the mounting screws.
WARNING Follow instructions carefully. Do not place the
equipment on an unstable support such as a
cart, stand, or table. The equipment could fall
and cause equipment damage or cause
personnel injury.