MQ Multiquip MP115E, Руководство по эксплуатации и запасным частям

Страница: 27 / 90

MP1 SERIES MASONRY SAW • OPERATION AND PARTS MANUAL — REV. #2 (10/12/17) — PAGE 27
9.
Rotate the
throttle lever
(Figure 26) halfway between
fast and slow for starting. All cutting is done at full
throttle
. The engine governor speed is factory set to
ensure optimum blade operating speeds
Figure 26. Throttle Lever
10.
Grasp the starter grip (Figure 28) and slowly pull it out.
The resistance becomes the hardest at a certain position,
corresponding to the compression point. Pull the starter
grip briskly and smoothly for starting.
Figure 27. Starter Grip
11. If the engine has started, slowly return the choke lever
(Figure 25) to the
"OPEN"
position. If the engine has
not started repeat steps 1 through 5.
12. Before the saw is placed into operation, run the engine
for several minutes. Check for fuel leaks, and noises
that would associate with a loose guards and/or covers.
13. Gradually move the engine throttle lever toward the
fast position. (All cutting should be done at full throttle)
Squeeze the water pump priming bulb (Figure 28)until
water begins to flow through the water lines. If the pump
is working correctly, the cutting blade should be covered
with a steady water mist. This will keep the blade cool.
Figure 28. Priming Bulb
OPERATION
14. Push the conveyor cart with the material, slowly and
evenly until the cut is complete. Move the cart back
and remove the cut pieces.
15. Avoid overloading the engine when cutting. In the
event that the engine becomes overloaded, turn the
engine ON/OFF switch to the OFF position and allow
the engine to cool before attempting to restart.
STOPPING
1. Set the engine throttle lever to
slow
speed and let
the engine idle for 3-5 minutes.
2. Turn the engine ON/OFF switch to the "OFF" position.
3. Place the fuel valve lever in the closed position.
4. Let the engine cool.
5. Using a soft cloth, clean any excess debris or residue
that may have accumulated on the saw.
6. Store saw in a clean dry location where it will be out
of the reach of children.
WARNING
ALWAYS cut with the saw at FULL THROTTLE.
Attempting to cut with the saw at less than full throttle
could cause the blade to bind or stop abruptly in the
slab resulting in serious injury to the operator or others
in the area.
DANGER
ALWAYS be alert to the fact that there is a rotating
blade on the saw and be extremely aware of your body
position — especially your hands in relationship to the
rotating blade. The possibility exists of severe bodily
harm or even death if your body comes in contact with
the rotating saw blade.
CAUTION
A
Engine components can generate extreme
heat. To prevent burns,
DO NOT
touch
these areas while the engine is running or
immediately after operations.
NEVER
operate
the engine with heat shields or heat guards
removed.