MQ Multiquip MP115E, Руководство по эксплуатации и запасным частям

Страница: 26 / 90

PAGE 26 — MP1 SERIES MASONRY SAW • OPERATION AND PARTS MANUAL — REV. #2 (10/12/17)
START-UP PROCEDURE (ENGINE)
NOTICE
Read and fully understand this manual before
starting or attempting to operate the saw.
Before starting the saw’s electric motor
make sure that the Safety, General Information, and
Set-Up sections have been completed and understood.
DO NOT proceed until the above mentioned sections
have been completed.
WARNING
NEVER
operate the saw in a confined
area or enclosed area structure that
does not provide ample free flow of
air
WARNING
ALWAYS wear approved eye and hearing
protection before operating the saw.
WARNING
NEVER place hands or feet inside the belt
guard or blade guard while the motor is
running.
ALWAYS
shut the motor down
before performing any kind of maintenance
WARNING
NEVER
place hands and fingers near
the cutting blade. The possibility exists of
severe bodily harm if hands and fingers
come in contact with rotating saw blade.
WARNING
ALWAYS
ensure that the cutting blade has
been mounted correctly.
OPERATION
6. Place the engine fuel valve lever (Figure 22) to the
“
ON
” position.
Figure 22. Engine Fuel Valve Lever (ON Position)
7. Place the Engine ON/OFF switch (Figure 23) in the
"ON"
position.
Figure 23. Engine ON/OFF Switch
Figure 24. osition)
8. Place the choke lever (Figure 25) in the
“CLOSED”
position if starting a cold engine.
Figure 25. Choke Lever
NOTICE
The CLOSED position of the choke lever enriches the
fuel mixture for starting a
COLD
engine. The
OPEN
position provides the correct fuel mixture for normal
operation after starting, and for restarting a warm
engine.