MPS M.C. Rexx QD2000 Series, Используйте руководство по уходу и запасным частям

Страница: 9 / 54

9
Cust
omer
Supp
or
t
M
ain
tenanc
e
O
pe
ra
tin
g I
ns
tru
ctio
ns
Troublesho
oting
Sa
fet
y In
stru
ctio
ns
As
se
m
bly
ASSEMBLY INSTRUCTIONS - continued
The optional patient helper consists of a bracket mounted to the frame, and an
arm with an adjustable handle. The arm can be located in three positions by use
of a locking spring pin. There is a side position for assistance entering and exiting
the bed (A), an in-bed position for assistance with repositioning (B), and a storage
position (C). The chain is attached using a “quick link” that allows the height and
position of the handle to be easily adjusted. You must follow the instructions
provided with the Helper.
WARNING!
Ensure that the spring loaded Pull Pin is properly engaged to prevent the Patient
Helper Pole from rotating. Failure to do so could result in serious injury.
Patient Helper -
optional
A
PULL PIN
B
C
Bed Extender -
optional
The bed extender is designed to be attached at the foot or at the head end of
the bed. The extender attaches directly to the foot or the head deck. If a foot
or head board is to be used with the extender, then a set of board extender
brackets are required to offset the foot or head board, and allow clearance for
the extender. The mattress pad extends the actual sleep surface.
To meet FDA Entrapment Guidelines a Side Rail Extender must be used on
beds equipped with 1/2 Length Side-Rails.
WARNING! POSSIBLE INJURY OR DEATH
Use only the proper size mattress and
extension pads in order to minimize the Entrapment Zone gaps. The gaps must be small enough to
prevent the patient from getting his/her neck caught in this location (you must read and follow the
FDA Entrapment Guidelines).
Mattress Stops Installation
Tools Required: 5/16 and 3/8” wrenches.
Parts Included:
Item # Qty Part Number Description
1 4 QS3484 CORNER MATTRESS STOP
2 8 QP2501 MACHINE SCREW #10-32 X 5/8” HEX HEAD ZP
3 8 QP2502 NUT 10-32 HEX NYLOCK ZP
1- Raise the bed to make the installation easier.
2- Place one Mattress Stop (1) in one corner overlapping the pre-punched holes; as illustrated.
3- Place one Screw (2) through one of the holes and thread a Nut (3) onto the screw behind the deck frame.
Tighten Nut finger tight . Repeat for the other hole.
4- Tighten the screws with a 5/16" Wrench while using a 3/8” Wrench to prevent the nut from spinning.
5- Repeat for the other 3 corners of the bed.
6- Tighten all screws.
Procedure:
2
3
1