MPE CHAIN-VEY, Руководство по установке и эксплуатации

Страница: 18 / 26

17
Maintenance:
Maintenance should be carried out by trained personnel in order to avoid personal injury or damage
to equipment. Deviations from normal performance (higher power input, higher temperatures,
vibration, unusual noises or odors, etc.) indicate that functionality of the unit is impaired.
The frequency of inspections is dependent on several variables, but the should be routinely
addressed.
1. Routine Equipment Inspections
Drive Unit
1
Ensure that all hardware on the sprocket is present and tightly fastened.
2
Inspect the sprocket teeth for wear
3
Check the gearbox oil level, and add oil if needed
4
Test the air-jets for proper pressure and flow
5
Clean the fins of the motor fan to optimize cooling
6
Verify the motor and gearbox mounting bolts are tightly fastened
7
Inspect the shaft oil seal for wear or damage
8
Remove any product build-up from all internal surfaces
Turnaround Unit
1
Check for proper tensioning, and note any changes since last inspection
2
Ensure that all hardware on the sprocket and tensioning plate is present and tightly
fastened
3
Inspect the sprocket teeth for wear
4
Inspect the sliding plates for excessive wear
5
Check the position and functionality of the tension switch
6
Remove any product build-up from all internal surfaces
Discharge Valve
1
Inspect the alignment and open/close of the drop-tube
2
Verify the proper functioning of the open/close reed switches on the rotary actuator
3
Remove any product build-up from all internal surfaces
4
Test the air-jets for proper pressure and flow
Pipe / Elbows
1
Inspect all floor and ceiling supports for misalignment and verify that all hardware is
present and tightly fastened
2
Check for any dents or damage which may affect the inner diameter of the pipe
3
Inspect the inner walls for excessive wear or abnormal build-up of material
Chain / Disc
1
Inspect the discs for wear and/or damage on the outer edges
2
Examine the chain for any excessive wear
3
Check the welds on the chain links for any sign of potential failure
4
Confirm that connector link wiper disc is fully intact
5
Confirm that the connector link hardware is present and tightly fastened
Sight-Glass
1
Check for any discoloration or any other obstruction of visual clarity
2
Inspect for any scratches or cracks
3
Confirm that the grounding wire is intact and in good condition
Inlets
1
Remove any product build-up from all internal surfaces
2
Check the inlet baffles (if present) for the proper flow control settings