MPC B-2354-111, Инструкция

Страница: 7 / 13

STEP 3: Programming
Program the EVO-ALL Module
Your EVO-ALL module now needs to be paired to your vehicle. Before starting the programming
sequence, make sure that none of the connectors are plugged into the EVO-ALL. Instructions for
programming the EVO-ALL are below. Here are two important tips to help you avoid common
mistakes:
• You will first need to plug the 4-pin data cable into the RS brain. It provides power and ground
to the EVO ALL module.
• While holding the button down on the EVO-ALL (step 1 in the programming instructions), insert
the black end of the data cable WITHOUT the locking tab into the EVO-ALL black receptacle.
• Step 2 in the instructions is all about the timing. The LED lights will start to cycle colors and
continue to cycle until you let go of the button. Release the button at the moment the LED is RED. If
done correctly the LED will remain solid RED when you release the button. If it’s not solid RED,
unplug the 4-pin connector and start over.
Page 7 of 13