MPC B-2354-111, Инструкция

Страница: 10 / 13

This connection is only needed if the EVO module is not doing 3 lock start thru the data connector.
Here is how to test. After successfully programming your evo module (led lights must flash exactly
as shown in each program step) with all other connections made to the remote start module, close
hood and doors. While sitting in the vehicle, press your factory remote LOCK button 3x's. You
should see the blue led on the evo module flash w/each LOCK press (3 blue flashes) and the car will
start shortly after. If so, install is complete. If this test does not work then you will need to make
the connection shown below.
The GREEN wire from the small red 3-pin plug of the remote starter takes a (-) ground pulse signal
from the door lock motor wire and uses that as a trigger to begin the remote start sequence. That’s
how pressing ‘lock’ on your OEM remote 3 times starts the vehicle. Touch the GREEN wire to
ground 3x's for testing. The car should start if all other connections and programming were done
correctly.
If this connection is needed, contact us for door lock wire info @ https://ts.mypushcart.com/ticket
Once you have identified the Start Activation (Lock Motor) wire in the vehicle, make the
connections to the relay as shown on the diagram below.
Page 10 of 13