MPC B-2354-111, Инструкция

Страница: 2 / 13

Overview
There are 5 basic steps to this remote start installation:
1. Preparation
2. Wiring
3. Programming
4. Testing the system
5. Finishing up!
STEP 1: Preparation
Beginning the Installation:
Tip #1 – Where Everything Goes
• When you open up your remote start, you’re going to see a whole bunch of wires. Don’t be
intimidated – you’re only going to be using a few of them. The remote starters are designed with
wiring options for a variety of cars and no car is going to use all of them. The wire charts and
system wiring diagram will show you the wires that you’re going to need and where they connect
in your vehicle. Any wires that are not shown to connect in this guide will not need to be
connected.
• Remote start and bypass modules – Before you start wiring, look for a location where there’s
some open space that will fit the modules. Pay attention to moving parts like the pedals, e-brake
and steering column. Be sure to route your wiring away from those areas. Carefully remove the
lower knee bolster, plastic steering column shroud, and any other panels required to gain access to
the needed vehicle plugs. Remember the order that you remove the panels. It is best to route
your wires along with the vehicles factory wires, as this is typically a safe location and it keeps the
install neat. Once you have accessed the needed locations in the vehicle use the plugs, pin positions
in the plugs, and wire colors shown in this guide to identify the correct wires that you will need to
connect from the remote starter to the vehicle. In most cases, the wires on the remote start are
way longer than needed. Trim off the excess wire when you make your connections, but leave
some slack, this will allow you some flexibility when it comes time to stow the remote start after
the installation is completed.
How to Make Wire Connections
Strip - Poke - Wrap and Tape method is the best wire connection that you can make. You MUST use
this method for the Can High and Can Low wire connections. Do not solder unless you know how to
do it really well.
Click here for directions on how to Strip/Poke/Wrap/Tape the wires
Page 2 of 13