Moyer Diebel MD2000-HR, Инструкция по установке, эксплуатации и ремонту

Страница: 25 / 48

Operation
Rinse Sentry Mode
The final rinse water temperature must be a minimum of 180ºF/82ºC during the final rinse cycle to
ensure that all wares are sanitized. If for any reason, the hot water temperature in the booster tank
can not provide this temperature, the dishwasher will enter a Rinse Sentry Mode of operation
and extend the cycle time.
The Rinse Sentry changes the Normal Mode as described below:
1.
The Rinse Sentry constantly monitors the water temperature inside final rinse booster.
2. If the temperature inside the booster heater falls below 180ºF/82ºC then the Rinse Sentry
will extend the wash cycle time until the booster heater water temperature reaches the
proper temperature.
3.
The incycle light will remain illuminated during the Rinse Sentry Mode.
4.
The RINSE water temperature gauge must be monitored to ensure that a minimum of
180-195ºF/82-91ºC. is maintained during the rinse cycle.
5. An extraordinarily long wash cycle may indicate a low incoming water temperature or a
problem with the booster heater operation.
DO NOT REMOVE WARES UNTIL THE FINAL RINSE CYCLE HAS
SANITIZED THE WARES AND THE GREEN CYCLE LIGHT GOES OUT.
The dishwasher can be drained automatically when the dishwasher has completed a n
ormal wash cycle or whenever the dishwasher is idle.
To drain the dishwasher:
1.
Turn the dishwasher Power Switch OFF. The automatic drain valve will open and the
machine will drain.
2. The drain valve will remain open for 10 minutes for the operator time to flush the interior
with fresh water during a cleaning operation.
3.
When 10 minutes has elapsed, the drain valve will close.
4.
The automatic drain cycle is complete.
NOTE:
The automatic drain cycle can be repeated after 10 minutes by turning the power Switch ON and
immediately OFF. The dishwasher will drain for another 10 minutes and then turn off.
Automatic Drain Cycle
17