TAP-125-U-W-X-Z
(YYYYYYYY)
Web Console Configuration
3-19
Policy
Setting
Description
Factory Default
Accept
Only the packets fitting the entities on list can be allowed.
Drop
Drop
Any packet fitting the entities on list will be denied.
IP Protocol Filter
The TAP-125-U-W-X-Z (YYYYYYYY)’s IP protocol filter is a policy-based filter that can allow or filter out IP-based
packets with specified IP protocol and source/destination IP addresses.
The TAP-125-U-W-X-Z (YYYYYYYY) provides 8 entities for setting IP protocol and source/destination IP
addresses in your filtering policy. Four IP protocols are available: All, ICMP, TCP, and UDP. You must
specify either the Source IP or the Destination IP. By combining IP addresses and netmasks, you can specify a
single IP address or a range of IP addresses to accept or drop. For example, “IP address 192.168.1.1 and
netmask 255.255.255.255” refers to the sole IP address 192.168.1.1. “IP address 192.168.1.1 and netmask
255.255.255.0” refers to the range of IP addresses from 192.168.1.1 to 192.168.255. Remember to check the
Active check box for each entity to activate the setting.
Enable
Setting
Description
Factory Default
Enable
Enables IP protocol filter
Disable
Disable
Disables IP protocol filter
Policy
Setting
Description
Factory Default
Accept
Only the packets fitting the entities on the list can be allowed Drop
Drop
Any packet fitting the entities on the list will be denied
TCP/UDP Port Filter
The TAP-125-U-W-X-Z (YYYYYYYY)’s TCP/UDP port filter is a policy-based filter that can allow or
filter out TCP/UDP-based packets with a specified source or destination port.
ATTENTION
Be careful when you enable the filter function:
Drop + “
no
entity on list is activated” = all packets are allowed
Accept + “
no
entity on list is activated” = all packets are denied
ATTENTION
Be careful when you enable the filter function:
Drop + “
no
entity on list is activated” = all packets are allowed.
Accept + “
no
entity on list is activated” = all packets are denied.
