Moxa Technologies ICF-1150 series, Быстрое руководство по установке

Страница: 8 / 11

- 8 -
ATTENTION
This is a Class 1 laser/LED product. Do not stare into the laser
beam.
Federal Communications Commission Statement
FCC: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Switch Settings
There are 4 DIP switches on the front panel of the ICF-1150.
Setting Switch 1 Switch 2
RS-422 ON OFF
2-wire RS-485 OFF ON
4-wire RS-485 OFF (default) OFF (default)
Fiber Mode Switch 3
Ring Mode ON
Point to Point mode OFF (default)
120Ω Terminator Switch 4
Enable ON
Disable OFF (default)
For Fiber Ring Users:
If the Rx LEDs of the converter glow continuously, remove the
fiber cable and then reconnect. The Rx LEDs should no longer
glow continuously.
NOTE: “Ring Mode” can only be used for half-duplex
applications.
The S3 DIP Switch is located inside the ICF-1150. When the ICF-1150
is in RS-485 mode, use this DIP switch to configure RS-485 data
direction control, data format, and baudrate. When the ICF-1150 is in
RS-232/422 mode, the S3 DIP switch cannot affect RS-232/422
communication.
Direction Control and Data Format Setting
You will need to open the product's casing to do the Direction Control
and Data Format Setting.