—
18
—
Wiring the SPL-24’s Power Outputs
The two left-most contacts of the 3-contact terminal block connector on the
SPL-24’s top panel are used for 24 VDC output. Top and front views of one of
the terminal block connectors are shown here.
Top View
Front View
STEP 1:
Insert the negative/positive DC wires into the V-/V+
terminals.
STEP 2:
To keep the DC wires from pulling loose, use a small
flat-blade screwdriver to tighten the wire-clamp screws
on the front of the terminal block connector.
STEP 3:
Insert the plastic terminal block connector prongs into
the terminal block receptor, which is located on
SPL-24's top panel.
Technical Support Contact Information
www.moxa.com/support
Moxa Americas:
Toll-free: 1-888-669-2872
Tel: +1-714-528-6777
Fax: +1-714-528-6778
Moxa China (Shanghai office):
Toll-free: 800-820-5036
Tel: +86-21-5258-9955
Fax: +86-10-6872-3958
Moxa Europe:
Tel:
+49-89-3 70 03 99-0
Fax:
+49-89-3 70 03 99-99
Moxa Asia-Pacific:
Tel: +886-2-8919-1230
Fax: +886-2-8919-1231
