- 9 -
Wiring the Digital Inputs
The EDS device has one set of digital input (DI). The DI consists of two
contacts of the 4-pin terminal block connector on the EDS's right-side
panel. Refer to the instructions and diagram below on how to connect
the wires to the terminal block connector on the receptor.
STEP 1:
Insert the negative
(ground)/positive DI wires into the
┴
/I terminals, respectively.
STEP 2:
To keep the DI wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
button on the front of the terminal
block connector.
STEP 3:
Insert the plastic terminal
block connector prongs into the
terminal block receptor, which is
located on the EDS devices’ right side.
Rotating the Power Module
The power module for the EDS device can be rotated to make it easier
to fit your field site application.
Step 1:
Remove the two screws that fasten the power module to the
EDS device and remove the module.
Step 2:
Turn the power module clockwise so that the power, digital
input, and relay output connectors can be moved upwards.
Step 3:
Replace the module back on to the EDS device.
Step 4:
Fasten two screws on to the module.
