- 6 -
WARNING
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your AWK-4252A.
Calculate the maximum possible current in each power wire
and common wire. Observe all electrical codes that dictate the
maximum current allowed for each wire size. If the current
goes above the maximum ratings, the wiring could overheat,
causing serious damage to your equipment.
WARNING
•
This equipment is intended to be used in a Restricted
Access Location, such as a dedicated computer room where
only authorized service personnel or users can gain access.
Such personnel must be instructed about the fact that the
metal chassis of the equipment is extremely hot and may
cause burns.
•
Service personnel or users have to pay special attention
and take special precautions before handling this
equipment.
•
Only authorized, well-trained professionals should be
allowed to access the restricted access location. Access
should be controlled by the authority responsible for the
location with lock and key or a security identity system.
•
External metal parts are hot!!
Pay special attention or
use special protection before handling the equipment.
To remove the AWK-4252A from the DIN rail, do the following:
STEP 1:
Pull down the latch on the DIN-rail kit
with a screwdriver.
STEP 2 & 3:
Slightly pull the AWK-4252A forward
and lift it up to remove it from the
mounting rail.
Wiring Requirements
Read and Follow These Guidelines:
•
Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the crossing point.
