Depth regulator rod
Insert the depth regulator rod through hole in
the wheel bracket lock block from the top down
with curve to the rear of the unit and secure
with a O4 cotter pin through the holes in the
bracket lock block, passing through the desired
hole in the depth regulator rod.
Upper handle
Mount the upper handle on the lower handles
with the handle adjustment knobs.
2.
Disassemble the handle adjustment knobs.
1.
Upper
Handle
Retainer
Cone
Bolt
Inside
Adjuster
Lower
Handle
Konb
Outside
Adjuster
Throttle & clutch controls
Remove the M6X60 carriage bolt and nut from
the throttle control assembly. Mount the throttle
control on the left side of the upper handle with
the hardware removed. Make sure the throttle
control is mounted outside the handle.
2.
Unwind the throttle control and clutch control
from around the engine. Straighten the cables.
Make sure that you do not bend or kink the
cables.
1.
Remove the M6X40 socket screw and nut from
the clutch control lever assembly. Mount the
clutch control lever on the right side of the
upper handle with the hardware removed. Make
sure the clutch control lever is mounted on the
top of the handle.
3.
Use two cable clips to secure the clutch control
cable and throttle control cable in place on the
lower handles. Attach the clutch control cable
to the upper handle with another cable clip.
Make sure the control cables are routed properly.
4.
F
Wheels bracket
E
2
M10 20
3
8
Press down on the release pedal and insert the
lock block under the lock lever. Make sure the
spring-loaded lever locks in one of the grooves.
1.
Hook the wheel bracket on the tailpiece bracket
assembly.
2.
Secure the wheel bracket lock block on the
wheel bracket with two M10X20 screws and
teethed washers.
3.
Mowerland Tiller
