Lower handles
Remove the M8X260 screw, flat washer and
lock nut from the rear end of tiller chassis.
1.
Mounting holes for adjustment knob are
arranged in the top portion of each lower handle.
Make sure the 3-hole side of the handle is facing
inward. Insert the bottom portions of the lower
handles into the mounting channels located in
the underside of each side of the tiller chassis.
2.
Mount the flat washer on the M8X260 screw
removed. Line up the holes in the bracket,
handles and tiller chassis. Slide the screw
through the holes from one side, then lock nut
from the other side. Leave them untightened
at this time.
3.
Tilling tines
Place tilling tines on the tine shaft on both sides
of the gear box. Line up the holes in the tine frame
sleeves and tine shaft. Insert O10X50 clevis pins
through the holes in tine frames and tine shaft.
Insert O2.5 cotter pins through the holes in the
clevis pins to secure them.
On each side, slide on a M8X45 flange screw
through the holes in the mounting channel and
the lower handle, then screw a flange nut.
4.
B
M8 45
2
Tine shield extensions
Attach the tine shield extensions to the tine shield
with M5X12 screws and flange nuts.
C
6
M5 12
D
2
10 50
2
2.5
7
Tighten down all the screws.
5.
Mowerland Tiller
