Motus M660BR, Руководство по обслуживанию

Страница: 14 / 96

13
7) Remove the Drive Belt from the PEDAL PULLEY
(28) by pushing the upper surface of the Drive Belt
outward while rotating the Pedal little by little. Keep in
mind that removing the Belt under high tension may
make damages to the Belt and Bearings.
8) Install new Drive Belt in reverse order by installing
the Belt around the GENERATOR (5) PULEY first and
then walking it onto the IDLER PULLEY (8) and
PEDAL PULLEY (28).
You had better install the Belt while rotating the Pedal
little by little.
9) Adjust the tension of the Drive Belt. See 2.1 How to
Adjust the Drive Belt (or POLY V-BELT) Tension.
10) Re-install all of parts in reverse order.
Caution: To avoid risk of injury, it is recommended that
one person replaces the Belt rather than two persons.
2.2.2 M660BR/BRL
Do the steps below while referring to the following Exploded Views in Appendix.
I.1 M660BR/BRL_MAIN BODY
1) Turn off the unit power at the switch and unplug the line cord at wall outlet.
2) Remove two bolts (52) securing the CENTER FOOT_RE (59) to the Main Body Frame and
Remove the CENTER FOOT_RE (59).
3) Remove two bolts (50) securing the FRONT BODY CAP_FRONT/REAR (58, 57) to the Main
Body Frame and remove the FRONT BODY CAP_FRONT/REAR (58, 57).
4) Remove six bolts (46, 56) fastening the FRONT BODY_R (54) to the Body Frame and
remove the FRONT BODY_R (54) from the Body Frame.
5) To decrease the belt tension, turn the HEX NUT (14) counterclockwise until the HEX NUT
(14) reaches the end side of the TENSION BOLT (13) as shown.