Motus M660BR, Руководство по обслуживанию

Страница: 35 / 96

34
3.9 How to Replace the SMPS-5V (or MPU POWER SUPPLY) in M660BUL
and M660BRL
M660BUL
Do the steps below while referring to the following Exploded Views in Appendix and Section
4
ELECTRONIC PCB, CONNECTOR AND CABLE OVERVIEW.
C.1 M660BU/BUL_MAIN BODY
1) Turn off the unit power at the switch and unplug the line cord at wall outlet.
2) Remove the CENTER FOOT_UP (61) by removing two bolts (52) securing the CENTER
FOOT_UP (61) to the Main Body Frame.
3) Remove two bolts (55) securing MAIN BODY CAP (54) to the Main Body Frame.
4) Lift the MAIN BODY CAP (54) and SEAT POST CAP (56) and then fix these to the Gas
Cylinder temporarily by a tape to make it easy to remove the MAIN BODY_R (50).
5) Remove four bolts (51) securing the MAIN BODY_R (50) to the Main Body Frame.
6) Remove one bolt (52) securing the MAIN BODY_L (49) to the Main Body Frame and then
remove the MAIN BODY_L (49) from the Main Body Frame through the PEDAL_BU_L(40) and
CRANK ARM_L (41). Be careful not to make a scratch on the MAIN BODY_L (49) while
removing the MAIN BODY_L.
7) Remove all the cables which are connected to the SMPS-5V (36).
8) Remove the SMPS-5V (36).from the SMPS BRACKET_UP (34) by unscrewing four bolts (37).
9) Install new SMPS-5V (36).in reverse order.
M660BRL
Do the steps below while referring to the following Exploded Views in Appendix and Section
4
ELECTRONIC PCB, CONNECTOR AND CABLE OVERVIEW.
I.1 M660BR/BRL_MAIN BODY
1) Turn off the unit power at the switch and unplug the line cord at wall outlet.
2) Remove the CENTER FOOT_RE (59) by removing two bolts (56) securing the CENTER
FOOT_RE (59) to the Main Body Frame.
3) Remove the FRONT BODY CAP_REAR (57) and FRONT BODY CAP_FRONT (58) by
unscrewing two bolts (50).
4) Remove four bolts (46) securing the MAIN BODY_R (54) to the Main Body Frame.
5) Remove one bolt (56) securing the MAIN BODY_L (53) to the Main Body Frame and then