Motus M660BR, Руководство по обслуживанию

Страница: 16 / 96

15
6) Remove the CRANK CAP (45) from the CRANK
ARM_R (43) by using a tool with tip.
7) Remove the Bolt (44) securing the CRAMK ARM_R
(43) to the PEDAL SHAFT (27) by using 6 mm wrench.
8) The PEDAL TOOL for pulling the Crank Arm out is
shown. Maintain the PEDAL TOOL as shown in A by
placing the rear section of the PEDAL TOOL as
backward as possible.
9) Install the PEDAL TOOL into the hole of the CRANK
ARM_R (43) where the CRANK CAP (45) was extracted.
10) Insert the PEDAL TOOL into the hole of the CRANK
ARM_R (43) by turning the front hex-section of the
PEDAL TOOL clockwise with Adjustable Spanner as
shown.
11) Turn the rear hex-section of the PEDAL TOOL
clockwise as shown until the CRANK ARM_R (43) is
extracted from the PEDAL SHAFT.
12) Remove three Bolts (32) and remove the PEDAL IN
COVER (31).
13) Remove the Drive Belt (46). See 2.2 How to
Replace the Drive Belt
14) Remove the PEDAL PULLEY (28) from the unit by
removing four Bolts (29).
15) Remove the MAIN BODY_L (49), CRANK CAP (45),
CRANK ARM_L (41) and PEDAL IN COVER (31) in
opposite side while using same procedures as 5) thru
12).
16) Remove the SNAP RING (30) by using Snap Ring
Plier.
17) Pull the PEDAL SHAFT (27) out of the unit.
18) Install new PEDAL SHAFT (27) in reverse order.
19) Adjust the Drive Belt Tension before re-assembling the MAIN BODY_R (50). See “How to
Adjust the Drive Belt Tension”
20) Re-install all of parts in reverse order.