ZIM12-00505 Rev. 1
TransTech IV Service Manual
12
BASIC OPERATION
Control Panel
Pressure Gauge
Automatic Fluid Exchange Operation.
1. Make sure the TransTech IV new fluid tank is filled with the correct type and
amount of Transmission Fluid.
2. Connect TransTech IV power leads to the vehicle’s battery.
3. With vehicle running, pressure should be present at the TransTech IV pressure
gauge and the START ENGINE light should be on solid. If pressure drops to
zero, and START ENGINE light is flashing, the hoses may be reversed.
4. Press START/RESUME
button to begin the exchange.
5. When fluid exchange is finished, the COMPLETE
light will come on and
TransTech will beep continuously until STOP
button is pressed.
6. Once transmission service is complete, check ATF level with engine running.
Press and hold DRAIN
or FILL
to adjust ATF level. Stop the engine, the service
is complete.
7. Direct waste hose to a suitable container; open the ball valve on the end of the
waste hose and press EMPTY WASTE
button to empty dirty fluid tank.
