Motorola V8162, Руководство по обслуживанию

Страница: 31 / 93

Identity and Security
47X# set-aud
Sets the audio level to the value specified by X.
Audio level X is represented as 0 = lowest, 15 = loudest.
Range of 8-15 has DTMF Feedback boost bit enabled.
48# SIDETN
Enable sidetone.
(Command 05# must also be executed).
49# SIDETF Disable sidetone.
(Command 06# must also be executed)
50# -54# not used
55# Prog-nam nam
Programs the NAM through the handset.
This version uses supports only currently required NAM
fields and it supports programming of data logger bytes. At
the last step, the user enters a 1 to begin programming the
data logger bytes.
Handset key entry is defined in Table 1: “Handset
Command Key Entry” on page 13.
Refer to “NAM Programming” on page 25 of this manual
for programming details.
56# Auto-Cycle
Puts the radio in autocycle mode (CDMA only). Exit this
command with the # key.
This command causes the radio to infinitely loop between
2 cycles. One cycle is the display/transmit and the other is
standby. The display/transmit cycle has a duration of 90
seconds and the radio has the following setup:
- Display has all 8’s showing.
- Turn on variable rate random transmit data.
- Carrier is enabled.
The standby cycle has a duration of 4.5 minutes and the
radio has the following setup:
- Display is blank.
- Turn off variable rate random transmit data
- Carrier is disabled.
This test command forces the radio into CDMA mode.
Table 8:
Keypad
Entry
Command
Description
Status Display Result