ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1.
Attach ground fixture wire (silver or copper in color) to ground wire from wall
outlet box (usually green or copper in color), fasten together with a plastic wire
connector. Tightly wrap the wire connector with electrical tape so the end of
the connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
2.
Connect neutral (ridges molded) fixture wire coming from fixture base to
neutral (usually white) outlet wire. Fasten both wires together with a plastic
wire connector and tightly wrap the wire connector with electrical tape.
3.
Repeat the procedure with the hot (smooth covering) wires. Always make sure
that no wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY
WILL BE COMPROMISED.
4.
To detach back plate (A) from light fixture by unscrewing base screws (D).
5.
Position back plate (A) diagonally so that the holes of back plate (A) and
ceiling outlet box are aligned.
6.
Tighten the mounting plate onto the ceiling outlet with mounting screws (C).
7.
Gently push the fixture base (B) onto the affixed back plate (A), and secure
with base screws (D).
8.
Attach shade (G) to stem (E), slide shade spider on threaded section under
washer (F). And secure by turning washer (F) in clockwise direction.
9.
Screw rod (H) on bottom threaded nipple of part (E).
10. Insert light bulbs (not included) into sockets.
DRY
Simple Scallop Pendant
Item # BBL5016
