Motorola Dimetra MTM300, Руководство по установке

Страница: 53 / 58

Motorcycle Installation 45
4. Connect the Data cable to the junction box (if required).
Figure 50 Connections to Junction Box
Table 7 Mechanical Parts for FLN2451 Junction Box and FLN2483 Data Junction Box
Antenna Mounting
The recommended mounting location for the antenna is on the chassis or other stable part
on the motorcycle as far from the driver as possible.
Mount the antenna and shorten the antenna cable using the provided instructions.
Power Cable Installation
Before applying 13.8VDC primary power to radio for the first time, inspect wiring going
to accessory connector very carefully. Ensure that pin 1 (), and pin 2 (speaker-)
ARE NOT connected to chassis ground. Failure to follow this precaution may result in
permanent damage to the transceiver and require replacement of audio power amplifier
integrated circuit and/or complete transceiver board.
This radio must be operated only in negative ground electrical systems. Reverse polarity
will cause the cable fuse to blow. Check the vehicle ground polarity before you begin
installation to prevent wasted time and effort.
Callout No. Motorola Catalogue No. Description
1 0300139773 Screw (4)—not shown
2 1586069C01 Base Housing
3 1586070C01 Cover Housing
4 5486489F01 Raw Material Label
5 FLN8930A
FCN5969B PCB Assembly—not shown
PCB Assembly, Data Junction Box—not shown
6 0300140338
Screw (4)
7 3108509G22 Connector
Visor Microphone
Accessories
Transceiver-to-Junction Box
Connection
Control Head-to-Junction Box
Connection
Screws for securing the
junction box to the
mounting surface
Data Connection (available only
with Data Junction Box FLN2483)
Connection
Connection
3
2
4
7
6
!
C a u t i o n