Motorola Dimetra MTM300, Руководство по установке

Страница: 52 / 58

44 Motorcycle Installation
Control Head Connections
1. The control head-to-junction box cable is 2.5 m long. To determine the required
length, route the cable as required from control head to the junction box at the back
of the motorcycle. Be careful to route the cable in such a way that it will not be
subjected to abrasion, stretching, sharp bands or other types of injury.
If it is necessary to cut excess cable, this is done by cutting off the 15-pin D-sub
connector of the cable and shorten the cable to the required length. Make sure that
you have a spare 15-pin D-sub connector to replace the original connector.
Open the pin housing of the spare connector and connect the cable wires according
to Figure 49. Reassemble the pinhousing.
2. Connect the control head-to-junction box cable to the connector at the back of the
control head.
3. Connect the microphone to the microphone connector on the cable.
Figure 49 Wiring Diagram
Junction Box Installation and Connections
Installation
Secure the junction box by screwing the four supplied screws straight into the location.
Connections
1. Connect all accessories to the junction box terminal board (see Figure 39 and Figure
52).
2. Connect the control head-to-junction box cable to the junction box.
3. Connect the transceiver-to-junction box cable to the junction box.
PIN
15
14
13
4
8
9
7
3
17
18
10
11
12
1
2
5
6
16
BUS-(SB9600)
BUS+(SB9600)
BUSY (SB9600)
D_GND
RX_AUDIO
MIC_ON_OFF
D_GND
RESET
UNSWB+
SWB+
N.C
EMC_KEYFAIL
N.C
N.C
EMC_KEYLOAD
PIN
N.C
N.C
N.C
15
14
13
4
8
9
7
3
6
5
10
11
12
1
2
BUS-(SB9600)
BUS+(SB9600)
BUSY (SB9600)
D_GND
RX_AUDIO
MIC_ON_OFF
D_GND
RESET
UNSWB+
SWB+
N.C
EMC_KEYFAIL
N.C
AUDIO_GND
EMC_KEYLOAD
BLACK
WHITE
Twisted Pair
BLACK/RED
BLUE
VIOLET
GRAEY
BLACK/YELLOW
BLACK/ORANGE
YELLOW
BLACK/GREEN
RED
GREEN
Alu. Shielded
Alu. Shielded
JUNCTION BOX CONNECTOR CONTROL HEAD CONNECTOR