Motorola Dimetra MTM300, Руководство по установке

Страница: 39 / 58

Desktop Mounting 31
Desktop Mounting
General
The MTM300 may be desktop mounted. The Desktop Station option provides the radio
with an accessory plug, tray, desk microphone, and power supply for use at a fixed location.
There are two types of trays: HLN6404 with Speaker and HLN6405 without Speaker.
If Desktop Tray HLN6404 was ordered, Accessory Plug HLN6412 is required for
connecting the tray’s built-in speaker to the desktop station.
If Desktop Tray HLN6405 was ordered, External Speaker HSN4024 is required. The
external speaker is supplied with an accessory plug already attached to its cable and a strain
relief clip which is threaded over the cable between the speaker and accessory plug.
Planning is the key to fast, easy radio installation. Before a hole is drilled or a wire is run,
inspect the location and determine how and where you intend to mount the antenna, radio,
and accessories. Plan wire and cable runs to provide maximum protection from pinching,
crushing, and overheating.
The installation planning should only be undertaken by persons who are competent and
able to ensure that the complete installation fulfils its regulatory requirements, such as
EMC (ElectroMagnetic Compatibility).
To connect the radio, proceed as explained in the following paragraphs while referring to
Figure 33.
Installation Planning
Choose a location for the radio as close as possible to where the antenna cable enters the
building.
Be sure line voltage power is available.
Make sure sufficient air can flow around the radio to permit adequate cooling.
Choose a flat surface for the desktop tray and external speaker.
Be sure the mounting surface is able to adequately support the weight of the radio and tray.
Figure 33 Desktop Installation (with Tray HLN6404)