Motorola Dimetra MTM300, Руководство по установке

Страница: 18 / 58

10 Dash Mounting
2. Plug the accessory plug into the accessory connector.
3. Snap the strain relief clip, which is already threaded over the speaker cable and other
accessory wires (if any), into the slot at the back of the radio.
Figure 5 Strain Relief Clip Installation
4. Ensure that the plastic guides are aligned (horizontal) to the transceiver grooves.
5. Slide the radio into the plastic guides until it snaps into place.
6. Secure the radio with the two wing screws provided.
7. After mounting the antenna (see page 11), run the antenna coaxial cable to the radio
mounting location. If necessary, cut off the excess cable.
8. Connect the antenna cable connector to the BNC antenna connector at the rear of the
radio (see Figure 8). Ensure that the antenna’s cable connector is fully tightened. DO
NOT use an adaptor between the antenna cable connector and the radio.
Accessory Plug
Strain Relief Clip
Wires
Figure 6 Trunnion Mount—Transmission Hump Mounting Figure 7 Trunnion Mount—Below Dash Mounting
Wing Screw
Trunnion
Plastic Guides
Tabs
Wing Screw
Mounting Surface
Groove
Thread Hole for
Wing Screw
Trunnion
Wing Screw
Holes for
S-Hook