Help
47
13. Help
The handset is not charging when the handset is
placed on the base
• The handset has been placed incorrectly. Make sure that
the charging contacts on the handset are aligned with the
charging contacts on the base. During charging, the
icon in the handset display will scroll.
• Dirty contacts - Unplug from the mains power and clean
the charging contacts with a cloth. (Do not wet it and do
not immerse in water)
No dial tone
• No power - check the connections. Unplug the power
cable and plug it back into the mains outlet.
• Batteries are empty - charge the batteries for at least 24
hours. Replace the rechargeable batteries.
• You are too far from the base - move closer to the base
• Wrong line cord - only use the telephone line cord
provided
• Micro filter (when required, not included) is not
connected to the line cord - connect the micro filter to the
line cord.
Poor audio quality
• The base is too close to electrical appliances, reinforced
concrete walls or metal door frames - move the base at
least one metre away from any electrical appliances.
The signal icon is blinking
• Handset is not registered to the base - register the
handset to the base.
• You are too far from the base - move closer to the base.
• Switch ECO mode off.
No ring tone
• The ringer volume may be switched off.
• Increase
the
volume.
No Caller Display
• Check your subscription with your network operator.
• The caller may have withheld his/her number.
• The record cannot be found in your phonebook. Check
that you have the correct name/number stored in your
phonebook, with the complete area code.
A phonebook entry cannot be stored
• The phonebook is full. Delete unused entries.
No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base power supply.
Motorola_CD1_IFU_EN_UK.book Page 47 Wednesday, December 22, 2010 3:40 PM
