10A
10B
EN
EN
• ACCESS TO EXTENDED MENU 3
03. CONFIGURATION
EXTENDED MENU 3
EXTENDED MENU 3
STRENGTH LEVEL
LED'S ON
1
CODE
2
CODE • CODE PED
3
CODE • CODE PED • IN. CMD. AP.
4
CODE • CODE PED • IN. CMD. AP. • L. CORT
5
CODE • CODE PED • IN. CMD. AP. • L. CORT • PGM. AUT
6
CODE • CODE PED • IN. CMD. AP. • L. CORT • PGM. AUT • T. MOT
With the extended menu 3 it is possible to program the power / speed of the motor’s
slowdown.
To access the extended menu 3 options follow these instructions:
01.
Access the extended menu 1 (see page 7A).
02.
Access the extended menu 2 (see page 8B).
03.
Continuously press the
SET
button for 5 seconds and the
T.PAUSA LED
and
T. RIT.
ANTE LED
will flash alternately for a while, and blink at the same time right after.
04.
There are available 30 seconds to select functions from the extended menu 3 (using
the
SEL
and
SET
button), and after that time the control board returns to the main
menu.
Motor strength programming during the slowdown:
It is possible to choose up to six different levels, in relation to the strength that the
engine performs during the slowdown. The levels are represented by combinations of
the LED indicated in the table above.
Scroll through the LEDs with the
SEL
key to set the desired strength, knowing that
the
AUT / PP. LED ON
corresponds to the minimum strength, while the
AUT / PP., CODE
,
CODE PED
,
INB. CMD. AP
,
T. MOT.
,
T. MOT. PED LEDs ON
correspond to the maximum
strength.
The control board is supplied by the manufacturer with the strength set at level 3 (
AUT/
PP., CODE, CODE PED ON
).
RTX 2278-BASE MODULE (OPTIONAL)
• OPERATION
The RTX 2278 device (Base) controls through radio frequency up to two RTX 2252 devi-
ces (sensor) for security bands connection.
This device has two different menus – MONITOR and PROGRAMMING.
The
MONITOR
menu is the stand-by mode of the device and is only for information dis-
play. It has the following indications:
The RTX 2278-Base module is only used when applying a security bandat the gate or
pillars.
MONITOR MENU
LED
LED OFF
LED ON*
Flashing LED**
•
CODE SENSOR 1
No alarm
Alarm SENSOR 1
Battery or
communication Low
Battery/communication OK
•
CODE SENSOR 2
Nenhum Alarme
Alarm SENSOR 2
Battery or
communication Low
Battery/communication OK
*
Also issued a brief sound signal
**
Every minute are issued 2 short beeps sound signaling
•
Power
5V DC
•
Maximum consumption
25 mA
•
Operating frequency
Banda 868 MHz FSK
•
RTX 2252 storable sensors
2
•
Operating temperature
-10°C a 55°C
•
Dimensions
59x39mm
01
• Hot Pole Antenna Input
02
• Antenna Mass Entry
CN1
1
1
2
2
SW1
ANTENNA
BUZZER
CS2
• CODE SENSOR 2
CS1
• CODE SENSOR 1
M.P.
• MENU' PROG.
MON.
• MONITOR
• TECHNICAL SPECIFICATIONS
03. CONFIGURATION
