6A
6B
EN
EN
03. CONFIGURATION
MAIN MENU
To activate the pedestrian function, the control board allows a small opening programma-
tion.
NOTE
• To perform this programming is necessary that the engine has limit.
Instead of using the
SET
button on the receiver, you can use a command that is already
scheduled.
The unit is supplied by the manufacturer with a pedestrian working time set at 10 seconds
without slowdown.
Programming the pedestrian working time with deceleration (Gate closed):
01.
Press
SEL
button the times necessary until the
LED T. MOT.PED.
starts to flash.
02.
Press
SET
button for 1 second, to motor starts the opening. If the motor doesn’t
start the opening, invert wires connection 5 and 7, on CN2 connector (see page 2B).
03.
Press
SET
button for 1 second, when the gate is at the desired deceleration point.
04.
Press
SET
again, when you want to establish the opening limit-switch. At this
time,
T. MOT. LED
will flash quickly and the motor 1 will start the closure maneuver.
05.
Press the
SET
button when the gate is at the desired position to start the decele-
ration.
06.
Press
SET
again when you want to establish the closing limit-switch.
07.
The
T.MOT. PED LED
will remain lighted signaling that the working time is program-
med.
Programming the pedestrian working time without deceleration (Gate closed):
01.
Press
SEL
button the times necessary until the
LED T. MOT.PED
starts to flash.
02.
Press
SET
button for 1 second, to motor starts the opening. If the motor doesn’t
start the opening, invert wires connection 5 and 7, on CN2 connector (see page 2B).
03.
Press
SET
twice when you want to establish the opening limit-switch. At this time,
T. MOT. LED
will flash quickly indicating that programming for the closing can be perfor-
med automatically and the motor starts the closing move.
04.
Press
SET
twice when you want to establish the closing limit-switch.
05.
The
T.MOT. PED LED
will remain lighted signaling that the working time is programmed.
• T. MOT. PED |
PEDESTRIAN WORKING TIME PROGRAMMING
03. CONFIGURATION
MAIN MENU
• T. PAUSA |
PAUSE TIME PROGRAMMING FOR AUTOMATIC CLOSURE (4MIN MAX)
The control board is supplied by the manufacturer with automatic closure active after
10sec.
Disable the automatic closure:
01.
Press
SEL
button once, the
CODE LED
will begin to flash. Press the
SEL
button the
times necessary until the
LED T. PAUSA
starts to flash.
02.
Press the
SET
button twice in 2sec! The
T.PAUSA LED
turns off and the function is
disabled.
Activate or change the pause time for automatic closure:
01.
Press
SEL
button once, the
CODE LED
will begin to flash. Press the
SEL
button the
times necessary until the
LED T. PAUSA
starts to flash.
02.
Press once the
SET
button, wait the desired time for the pause time
and press again the
SET
button (the expected time is defined as the pause time).
The
T.PAUSA LED
remains lit and the pause time is active.
