Motor Scrubber STORM JET3, Руководство пользователя

Страница: 7 / 17

Important Information
Electrical
Connection
Important: before you
connect the power cable,
check the brush switch is
not on. (see page 14).
To connect the quick fit
stainless steel, electrical
connection, line up the
two red dots and push
until you hear a click.
To release the connection,
grip the textured areas
and pull apart.
Battery & Charging
Information
• The battery should be
charged before using
your MotorScrubber,
after each use, and if
unused for 4 months.
• When charging the
machine the red light
will show, when the
battery is fully charged
the light will show
green. A full charge
from flat will take
approximately 8 hours.
• Connect charger to
the charging port on
the left side of battery
compartment and
then plug the charger
directly into a 120
VAC/60HZ or 240 VAC
electrical outlet, or use
an adapter or a charger
made for the AC source
being used.
(Do not use an
extension cord). After
charging, disconnect
the charger from the AC
outlet and (IMPORTANT)
disconnect the charger
from the battery.
•
• MotorScrubber uses a
rechargeable sealed
lead-acid battery.
Non-spillable.
• Capacity: 12-volt, 7.0
amp-hour.
• Depending upon the
average depth of
discharge, over a
thousand discharge/
charge cycles can be
expected.
CHARGING
CHARGED
Additional Battery
Charge Setup
When you require long
periods of machine
usage, it is always advised
to have an additional
battery on charge so that
you can switch over to
a fully charged battery
quickly.
MSS28 (purchase separately)
MS1580
12V7ADC
12 13