Motor Scrubber STORM JET3, Руководство пользователя

Страница: 10 / 17

Adjusting The
JET3 Position
1. Unscrew the locking
knob, anti-clockwise
(Approx 4 full turns).
2. Pull the JET3 arm
outwards and rotate
to new position, push
in place.
3. Screw the locking
knob back into
position, clockwise.
Adjusting The
Flip Clip
1 2
3
Release the black clip by
pushing up the release
catch.
(1)
Adjust the pole
to your desired length,
then push the black
clip back into position.
Do not extend further
than the red stop line
printed on the handle.
If the telescopic pole is
slipping while in use,
you will need to ensure
the clip is tightened
appropriately. To do
this, locate the green
adjustment screw
(2)
and
ensure the black clip is in
an open position.
Being careful not to over
tighten, turn the screw
clockwise
(3)
until you
can comfortably push
the black clip back into
its lock position. If the
black clip is difficult to
push back, turn the green
screw anti-clockwise
until it is easy to push
back into position.
For an instructional
video please visit: www.
motorscrubberclean.com/
support
• When using
MotorScrubber make
sure the brush or
pad is flat to the
floor, this will ensure
smooth operation of
the machine and an
optimal clean.
• The JET3 is a low water
use cleaning machine.
Only a small amount of
detergent is required
to wet and clean the
floor, allow the brush
and powerful scrubbing
action to release the
dirt. The 1L / 0.21 gal
solution capacity can
efficiently clean up to
40m 2 / 430ft 2 .
• Do not use water hotter
than 35°C (95°F), this can
damage the valves and
pump.
• When the solution
bottle is nearly empty,
look for the jet to stop
spraying.
• Do not operate the
pump as this will create
an airlock. Simply
re-fill with chemical and
prime the pump.
• After every use, you
need to flush the
pumping system. To do
this fill the bottle with
clean water and hold
down the blue switch
for 60 seconds. Foam
will spray from the jet
and you will see this
change to clean water.
This is a vital step as the
valves and small pipes
can become damaged
or clogged with
chemical, if left to sit for
a long time. To maintain
your warranty this step
must be carried out.
• It is very difficult for us
to approve every single
chemical on the market,
the vast majority of
cleaning detergents
are safe to use with
your MotorScrubber
backpack. If you do
use some very harsh
chemicals, it is possible
that some components
life expectancy will
reduce, such as the
pump membrane,
check valve and
water-pipe. These
components are
all replaceable at
affordable costs.
Therefore using some
harsh chemicals may
result in more frequent
servicing.
• Scrub with straight,
light strokes. You can
exert light pressure
where needed, let
MotorScrubber do the
hard work for you.
DO NOT USE
MOTORSCRUBBER WITH
FLAMMABLE CLEANING
FLUIDS
FUSED PROTECTION
MotorScrubber is
equipped with 15Amp
replaceable fuse, to
protect against short
circuit. This fuse can be
found inside the battery
compartment.
Cleaning With JET3
18 19