Motor Scrubber STORM JET3, Руководство пользователя

Страница: 13 / 17

w
Application Instructions
Please read all application instructions carefully before using.
Start from the bottom and
spray upwards, to avoid
drips and runs. Use slow
controlled movements.
Vertical Surfaces
• Spray
• Inspect For Gaps
• Move On To Next
Touch Point
Flat Surfaces
(e.g. push plates)
• Spray
• Use Non-Absorbent
M-Wipes
(see page
06)
to ensure the
reverse side of the
object is covered with
disinfectant.
• Move On To Next
Touch Point
3 Dimensional Objects,
awkward objects
STORM
®
is safe to use on electronics such as keyboards,
and phones. STORM
®
will spray a fine mist which will
land on the surface and create a liquid layer, be careful
not to over spray the surface as there is a risk if too much
fluid is sprayed then it could enter the electronics and
cause a problem.
If you are concerned use M-Wipes to apply disinfectant
to electronics, dispense an M-Wipe and fold in half, then
spray disinfectant onto the M-Wipe until it is wet, then
wipe the electronics to ensure the full surface is covered
with a liquid layer of disinfectant, this method will
prevent excess liquid from entering into the electronics.
If you are ever unsure
that you have created
a perfect liquid layer,
wipe the surface with
a disposable, non-
absorbent wipe to spread
the disinfectant and
ensure perfect coverage
with no gaps.
Disinfecting Electronics
23
Personal Protective Equipment
and Safety Information
Please read all PPE and Safety advice carefully before using.
STORM
®
is a disinfectant
applicator. We have
various jet nozzles
available, which atomise
the solution at different
levels.
As with all spraying
equipment, it is possible
that some of the smaller
droplets will be inhaled
by the user, which
could be dangerous for
prolonged periods of
time.
Please check your
disinfectants MSDS
sheet, which will give
clear instructions of PPE
required when using their
product.
If unsure, contact
your disinfectant
manufacturer. Explain
how many hours of usage
you will be using the
product for. They can
then recommend what
PPE to wear to protect
yourself.
There are also non toxic
disinfectants available,
which don’t require PPE
to be worn.
Important:
If spraying hazardous disinfectants
for prolonged periods of time, we
recommend wearing a full face chemical
respirator, along with elbow length nitrile
gauntlets and disposable body suit. However,
please ensure you check your chemical
MSDS for accurate guidelines.
Additional factors to
consider.
There are 2 factors
to consider for PPE,
protecting yourself
from long exposure to
chemical disinfectants and
protecting yourself from
contracting Coronavirus
whilst performing
disinfection procedures.
Example: A FFP2/N95
respirator may protect you
from Coronavirus, however,
this will not filter chemical
vapours from harsh
chemicals. A thorough risk
assessment will need to
be performed to ensure
you have adequate PPE to
protect from Coronavirus/
other pathogens and also
adequate PPE to protect
you from prolonged
periods of chemical usage.
Fire Alarms
Unlike foggers which
pump out high volumes
of fog into the air,
foggers can set off
fire alarms. STORM
®
is
safe to use around fire
alarms, STORM
®
emits a
targeted controlled flow
of disinfectant designed
to be sprayed at 30cm
away from touch points.
There is no need to spray
fire alarms or ceilings
directly as nobody
touches these areas.
24 25