Motor Scrubber STORM JET3, Руководство пользователя

Страница: 11 / 17

Changing A
Motorscrubber
Brush
1. Turn the
MotorScrubber upside
down and support
with the inside of your
foot.
2. Line-up the tabs on
the disc with the hub
on the MotorScrubber.
3. Hold the hub firmly
to prevent rotation.
Press down while
turning the disc
clockwise until it locks
in place.
4. To remove, press down
on the disc and turn
it counter clockwise
holding hub until tabs
are free. Then lift off
the disc.
There are many ways
to remove dirty slurry
after cleaning, the most
effective ways are:
1. MotorScrubber can
be equipped with a
suction head, which
can be connected to
a wet vac for instant
slurry pickup.
2. Squeegee - Many
hard floor areas have
a drain in the floor.
Dry and remove the
slurry with your BLADE
floor squeegee into
the drain.
3. Attach BLADE A-Fibre
and dry.
Removing
Dirty
Slurry
Also available.
BLADE removes more
dirt, for a faster and
better daily clean.
Underwater
Use
• Because its motor
head can be
fully-immersed in water,
the MotorScrubber
is ideal for many
underwater cleaning
tasks. One of the
more popular uses of
the MotorScrubber is
cleaning the “scum line”
above the water level in
swimming pools, spas,
boats, etc.
• Immersing the head
for long periods of time
could effect its water-
proofing seals, due to
the effects of prolonged
heating and cooling. The
seals could contract and
allow water to make
direct contact with the
motor, which would
cause a motor failure.
Guidelines need to be
followed to avoid this.
• The seals should be
inspected once a month
to check for signs of
corrosion, that would
compromise its water
tightness. If the unit is
used underwater on a
regular basis, an internal
inspection of the head
is also required each
month by a competent
technician, this is to
check for water ingress.
WE RECOMMEND
NOT USING THE
MOTORSCRUBBER FULLY
SUBMERGED IN WATER
FOR MORE THAN 2
MINUTES CONTINUOUSLY.
MOTORSCRUBBER
SHOULD THEN BE
REMOVED AND ALLOWED
TO COOL FOR 5 MINUTES.
• Waterline cleaning,
where MotorScrubber
is half in and half out
of the water has no
limitations.
• Regular underwater
usage will reduce the
lifetime of the head unit.
MSGREY12V complete
motor head can be
purchased and replaced
when required. 1 year
is the suggested life of
regular underwater use.
Submerge
up to
25cm
away
from the
switches.
Fully submerged
Use for 2 minutes
then take out to cool
for 5 minutes.
Scum line cleaning
There are no
limitations, you can
clean continuous
using this method.
20 21