© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANULDNSINS003
03-21-18
www.motorcitywashworks.com
32
TOP WHEEL SETTING SCREEN:
Pic #66 Top Wheel Wash Settings Screen
SPIN/DRY BETWEEN CAR SETTING:
This function enables the top wheel to spin thru a succession of different speed cycles on the specially design
“
BEATER BAR
” between cars allowing the top wheel to maintain a level of “dryness” for proper operation. When
the “
SPIN/DRY
”
ON
button is pushed, the brush will spin between cars starting after the first car, between all the
cars and independently of the throughput. This option may be desired if the temperature in the Dry N’Shine area is
low and the ambient air is very humid or if the daily throughput is important. When the
“ON ONLY > 60CPH”
button is pushed, the brush will now start to spin between cars only and only when the throughput reaches 60 CPH
based on the total amount of
SONAR READY SIGNAL
over a period of
15 MIN.
AFTER HOURS
WASHES CYCLES SETTINGS:
Remember, your
DRY ‘N SHINE™
brushes will get dirty and will pick-up soil left on the vehicle after the wash
process. The
WASH
and
RINSE CYCLE
will clean the brushes on a periodic base. The
WASH
and
RINSE
CYCLES
are fully programed and some customizing is allowed to accommodate user’s requirements. Using the two
counters on the bottom left side of the screen; you may add
ADDITIONAL SOAP CYCLES
as well as
EXTRA
RINSE CYCLES
to the Top Wheel night wash cycle. Depending on the “dryness” of your wash environment, you
may want to add an additional
SPIN/DRY CYLE
to your
Top Wheel night wash cycle.
IMPORTANT NOTE:
A WASH CYCLES TAKES ABOUT 2.6 HOURS INCLUDING SPIN/DRY CYCLE.
ADDING EXTRA SOAP OR EXTRA RINSE WILL NOT INCREASE
SIGNIFICANTLY WASH CYCLE TOTAL TIME. HOWEVER, AN EXTRA DRYING
WILL ADD 2-1/2 HOUR TO A COMPLETE CYCLE
