© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANULDNSINS003
03-21-18
www.motorcitywashworks.com
26
If
you have purchase the
THREE WHEEL SYSTEM,
in order to
access the side wheels electrical motors,
loosen the top bolt located on the entrance side of the arm flange (see picture #56 below) and remove the
three other bolts secured through the flange (see pictures# 57 and 58) and then
TILT THE HEAD
ASSEMBLY DOWNWARD TOWARD THE ENTRANCE OF THE WASH
until the brush is laying flat on the
floor. Remove the cover from the motor (see picture #59) and connect the cable into the motor. Reinstall
the cover and reposition the head assembly.
LOOSEN
BOLT
REMOVE
BOLT
Pic #56: Loosen Head Bolt Pic #57: Remove Head bolt
TILT
DOWN
LOOSEN
BOLTS
Pic #58: Loosen Head Bolt s Pic #59: Tilt Head Down
Pneumatic Installation:
Your DRY N’SHINE TOP WHEEL
requires a supply of compressed air capable of
3 SCFM @ 100 PSI.
WARNING
!
IT IS IMPERATIVE TO SUPPLY THE TOP WHEEL PNEUMATIC
SYSTEM WITH CLEAN, DRY, COMPRESSED AIR.
ANY AMOUNT OF MOISTURE, VAPORIZED OIL, OR ANY
OTHER IMPURITIES WITHIN THE MAIN AIR SUPPLY MAY
AFFECT THE PERFORMANCE OF THE EQUIPMENT
AND LEAD TO PREMATURE WEAR OR MAJOR DAMAGE
TO THE ACCELERATOR™ DELIVERY SYSTEM OR ITS COMPONENTS.
Bring
a
3/8” OD
polyflow tubing air line from the main compressed air supply to the
CONTROL PANEL
MAIN AIR SUPPLY
(see picture # 61) and another one from the
CONTROL PANEL AIR REGULATOR
to
the top wheel main air panel.
REMOVE
