MOTOMA POWER CO., LTD
Http: // www.motoma.cn
E-mail: [email protected]
Manufacturer reserves the right to alter or amend the design, model and specification without prior notice.
16 / 27
alarm (which is resulted from non-use of the battery for a long time). Such case may be removed
after the battery is charged for 30min; if the alarm may not be removed, please press the reset
key RST for 10S, until all LEDs light up for reset, execute the battery reset operation and
confirm whether the alarm is removed. If the alarm is removed, the battery may be used normally.
Otherwise the battery shall be reworked.
2) For the battery which is normal after detection, please press the reset key RST for 3S to
execute the battery ON/OFF operation.
Instructions of
manual operation
of the reset key
RST
Startup
In the OFF state of BMS, press the key for 3S for startup;
Shutdown
In the non-standby state of BMS, press the key for 3S for
shutdown;
Reset
In the non-standby state of BMS, press the key for 10S, until
all LEDs light up for reset.
Instructions: “Shutdown” and “standby” and “startup” and “activation” in Chinese have the same
meaning.
3) Installation of the lithium battery, wiring and startup.
Make the battery pack in a standby state, install it in the battery cabinet one by one, the
anode and cathode of the battery pack are connected respectively, which are connected to the
switching mode power supply or UPS (Please note that the switching mode power supply and UPS
shall be disconnected from the AC). Press the reset key RST of one of battery packs for 3S
for startup. Such startup battery may activate other batteries which are connected in parallel
(or press the reset key RST of each battery pack for 3S successively) and the whole battery
pack with high capacity enters the working state. Later, apply AC to the power supply equipment
such as switching mode power supply and UPS to make the whole standby system run.
The specification of the connecting line is selected according to the load current, with the
common specifications of the connecting line as follows: