12.2 The level "Displ" (display)
All display relevant parameters can be adjusted within this menu. The level
Displ
includes the
sub-points
Unit
,
Scale
,
Day
,
Night
,
Flash
,
Aback and VertM,
which can be adjusted
individually.
12.2.1 Unit
Within this function the display indication can be changed from kilometers to miles (or v.v.) by
pressing the push button for time stage 1 (one bar appears). In order to leave the sub-point
engage the push button for time stage 2 (two bars appear).
12.2.2 Scale
With this function the setting of the LED engine speed indication is carried out. By pressing the
pushbutton for time stage 1 (one bar) the engine speed value can be set to 6.000, 8.000,
10.000, 12.000, 14.000 or 16.000 (rev./min). In order to leave the sub-point engage the
pushbutton for time stage 2 (two bars).
12.2.3 Day
The
motoscope mini
features an integrated brightness sensor that distinguishes between
daylight (
Day
) and darkness (
Night
).
Within the sub-point
Day
the brightness of the LED display can be adjusted for daylight. The
sub-point Day provides the modes
low
,
med
,
high
or
high+.
In order to choose one of these
modes the push button has to be engaged for time stage 1 (one bar).
In order to leave the sub-point engage the push button for time stage 2 (two bars).
Note: If the mode "
high+
" is activated a sufficient heat sink must be ensured. Such a heat
sink could be a holding bracket made of aluminum or steel, to which the two fastening bolts of
the device must have a direct contact. If no heat sink is possible, e.g. at an integrated gas tank
fitting, the outside temperature of the device can reach temperatures of up to 75° C. The
device switches off when the temperature exceeds a factory-set maximum. In such case the
brightness should be reduced to " high".
12.2.4 Night
Within this sub point the brightness of the LED display is set for darkness. The modes
low
,
med
,
high
or
high+
can be set by engaging the push button for time stage 1 (one bar). In
order to leave the sub menu engage the push button for time stage 2 (two bars).
12.2.5 Flash (shift light)
A threshold value for engine speed can be set within the sub-point
Flash
. The setting is used
for the adjustment of a simulated gear shift light. When exceeding the adjusted value all LEDs
of the display flash with maximum brightness and with a frequency of 5 Hz.
In order to select individual digits representing the desired threshold engage the pushbutton
for time stage 1 (one bar). In order to go to the next digit, engage the button for time stage 2
9
