11.5 Total odometer (in km or mi)
The total odometer shows the total distance covered since the instrument was put into
operation, provided that no other starting value has been entered. The reading can be shown
in kilometres or miles. The value remains stored even if the entire board is switched OFF. The
total odometer can be reset to 0 within the special sub-menu "RESET/ALL" in the set-up. If
you wish to enter starting values other than zero they can be set under "RESET/ODO".
11.6 Engine speed indication on the display (in rpm)
This function shows the current engine speed as a numerical value on the display in a range
between 0 and 20,000 rpm. This indication also requires vehicle specific pre-settings in the
setup menu.
11.7 Time counter for the current ride (hh:mm:ss)
The time counter for the current ride (stop-watch) measures the actual riding time because
counting stops when the vehicle stands idle. The riding time is recorded to the precise second
up to 99 hours, and 59 minutes. If the measured time amounts to less than 59 min and 59 s
the display shows minutes and seconds (mm.ss). If more time than one hour elapses, the
display shows hours and minutes (hh:mm). The recorded time remains also stored when
voltage is switched off. The time value can be set to zero any time keeping the pushbutton
pressed.
11.8 Threshold indication of the engine speed (shift light)
When a pre-adjusted engine speed value is reached (SETUP/ DISPL/ FLASH) all LEDs of the
display flash with a frequency of 5 Hz and with maximum brightness.
12 The Setup menu (adjusting the instrument)
All operations, adjustments, and calibrations of the
motoscope mini
are carried out using a
single pushbutton. For this reason the internal design of the setup is laid out in logical "levels."
The selection of and access to these levels as well as to their sub-points is controlled using
different button compression times. The different times are represented visually by a
horizontal LED bar in the first line of the display. This optical control ensures an easy
navigation as well as a correct input of data.
In order to enter the set-up menu the pushbutton has to be engaged in the "Speed" mode until
"
Setup
" appears in the display. Subsequently, the sub-point
Param
appears. Within this sub-
point three different levels can be chosen (
Param
,
Displ
and
Reset
) by compressing the
pushbutton for a short of time (time stage 1).
12.1 The level PARAM (vehicle-specific adjustments)
The navigation to this sub-point is explained by the diagram in the appendix (section 16.2).
Within this level the vehicle-specific values are entered which are needed for the indication of
the driving and engine speed. Within the level the sub-points
Teach
,
Circ
,
ImpW
,
ImpE
, and
Ver
can be chosen.
7
